An air source heat pump standing on a lawn beside a brick house.

Renewable installs

Renewable installs

An air source heat pump takes heat from the outside air and uses it for the heating and the hot water. It is sized for the house you have, then tied in with the pipework and radiators already there.

The outdoor unit sits outside the house and feeds a lower flow temperature than an old boiler. The radiators, or an underfloor circuit, have to be able to heat the rooms at that temperature. Where they cannot, they are changed as part of the same job. The heat loss of the house decides the size of the unit, including a Scottish winter, not a figure copied from another property.

Hot water is stored in a cylinder sized for the bathrooms. Controls are set so the pump runs for the rooms you use. The existing boiler can stay as a backup, or come out, depending on the system. The pump is installed, filled and handed over working.

What we do

  • Air source heat pumps
  • Sized for the heat loss of the house
  • Radiators, underfloor heating and hot water
  • Installation and handover